A typical situation is that you bought a new washer, but during installation you realized that the drain hose does not reach the sewer. If there is no way to move the machine closer - it does not matter. The best way out is a drain hose extension for the washing machine. Using the advice of experienced professionals, you will lengthen the drainage system quickly, easily and without harm to the device.
Necessary materials
Before you go shopping, take the necessary measurements:
- Measure the length of the distance that was not enough to the sewer pipe (siphon) to determine the length of the pipe. It is better to buy longer and trim the excess than not to finish. Initially, the SM developers calculate the drain length based on the pump capacity, so adding extra meters increases the load on the pump. If the distance to the sewage system is three times higher than normal, this is fraught with breakdowns of the pump, stagnation of water in the sleeve, tank, and the appearance of an unpleasant “swamp” smell in the drum.
- Measure the diameter of the drain hose. It is desirable that the diameter of the additive coincides with the "native". If the extension cord is narrow, it can be torn off by pressure and a flood will occur.
Shopping list:
1. Hose extension.
It is great if it will be the same brand with the machine, but this is not necessary. The main thing is the desired length and diameter. The cost depends on the length and quality - from 9 rubles to 200 and above. For example, for 200 rubles you can purchase corrugated, sliding and independently adjust the length from 1.5 to 5 meters.
2. The connector.
It is also called a connector or fitting. Experienced locksmiths and plumbers affectionately refer to this spare part as a "brush." When choosing a part, you will need the previously measured diameter. Since the connector is double-sided, the cross-section of each side must coincide with the hose ends. The cost may vary depending on the size and material, 10-20 rubles on average.
3. Clamps.
Two of them will be needed - for fixing the limit switches on the connector. A reliable option is plumbing or automotive metal clamps. The range allows you to take a walk - a variety of materials, models, sizes. Therefore, prices vary, but it is quite possible to purchase one ring for 15 rubles.
4. Phillips screwdriver. To tighten the clamps, most likely, you will not have to purchase it, this tool can be found in any home.
How to extend the drain hose?
Step-by-step instruction:
1. Put on a trailer clamp, then attach it to one side of the fitting.
2. Do the same on the extension side.
3. Tighten the clamps.
4. Attach the extension cord to the pipe of the sewer pipe or drain siphon.
5. Run the test mode.
See how simple it is? Shopping took longer than the process itself. This trick can be done from the inlet hose, if the water pipe is located far enough.
Important points
When connecting the drainage system, be sure to read the instructions, because the technical features of the model often affect the installation rules.
Universal recommendations:
- Bend the hose with the Latin letter S and fasten to the back of the housing.
- Position the elbow 40 cm from the floor.
- The connection should be on the upper side of the pipe, not the bottom, otherwise part of the water will remain.
- Use sealants to strengthen joint joints.
- Do not spare money on quality parts; it’s cheaper to pay once for good quality than to eliminate the consequences of a flood.
As you can see, lengthening is easy to do on your own, without the help of professionals. The main thing is to stock up on everything you need, follow the instructions and safety precautions. Illustrative example in the video:
We wish you easy and successful work!